The vacuum scrubber filter is a cloud piece that sits in front of the vacuum motor in a dirty water tank. This filter is installed in the device to prevent waste and fine particles from contaminated water. The entry of particles and fine contaminants collected into the suction motor of the scrubber can damage it. The vacuum filter, which is about 1.5 cm thick, can filter the waste well.
The importance of having a vacuum filter in an industrial scrubber
Industrial scrubber with the ability to suck water and contaminants removed from the surface is able to provide a high quality of cleanliness in the environment. Water and contaminants may contain tiny particles that enter the suction system of the device causing damage. Therefore, to prevent the entry of these contaminants into the tank and the suction motor of the scrubber, a vacuum filter is used at the inlet. Using this seemingly simple filter can prevent defects and damages in the industrial vacuum scrubber motor and greatly reduce the cost of maintenance and repair of the device.
Tips for using and maintaining a vacuum filter
Following some simple tips can have a significant impact on the performance of the scrubber. These points include the following:
The dirty water tank and filter should be washed after each use of the scrubber. After washing and drying the filter can be put in place. After using the scrubber for a while, the accumulated waste in the filter will harden and will not be easily removed and washed. In such cases, the filter should be replaced. In some cases, the sucked particles may damage the filter and rupture it. In this case, the filter must be replaced before using the scrubber. If the vacuum filter is not replaced in time, the possibility of particles entering the engine part and serious damage will increase, which will cause the scrubber dryer to fail.
The importance of replacing parts and vacuum filters in the scrubber
Some parts of the scrubber, such as brushes, squeegee, and vacuum filters, are considered consumable parts. During the time and use of the scrubber, these parts will lose their efficiency after a while, depending on the amount of use, surface material, and the amount of environmental pollution. This will reduce the efficiency, performance, and quality of washing and cleaning with an industrial scrubber. Therefore, replacing damaged or worn parts in the fastest time, will not only maintain the efficiency and quality of cleaning the machine but will also reduce the possibility of serious damage to the main equipment and parts of the industrial floor cleaner.